A remodeled kitchen corner with a farmhouse sink, pale cabinetry and open timber shelves

Advice

What Should I Know About Cabinet Refacing?

Most people who call about cabinets have already decided they need new ones. Often they do not, and the test for which is which takes about a minute.

5 minute read

Three jobs, not one

Repair is right when the boxes are sound and the failures are mechanical. A drawer slide gone, a hinge pulled out of soft wood, a door that no longer sits flat, a delaminated edge beside the sink. These are cheap fixes and they buy years.

Refacing is right when the boxes are sound and the layout works, but the doors are dated. New doors and drawer fronts, new hardware, and the exposed box sides veneered or painted to match. The room changes completely for a fraction of a replacement, because the expensive part of a kitchen is the carcass and you are keeping it.

Replacement is right when the boxes themselves have failed, or when the layout is the actual problem. Refacing a bad layout only buys you a better looking version of the kitchen you already dislike.

The test that settles it, and it takes a minute

Open the cabinet beside your sink and the one under it. Press your thumb firmly into the bottom panel near the back, and run a finger along the bottom edge of the door frame.

If it is solid and dry, your boxes are fine and you are a refacing candidate. If it gives slightly, feels spongy, or you can see the edge has swollen and separated into layers, that is moisture damage in particleboard and it does not come back. Refacing a swollen box is putting a new door on a carcass that is already failing.

On the Gulf Coast this is the deciding factor far more often than anywhere else in the country, because humidity finds every raw edge eventually and cabinets under a sink get the worst of it.

What refacing does not fix

It is worth being plain about the limits, because this is where people end up disappointed.

A layout you do not like
If the corner cabinet is unreachable now, it will be unreachable with a new door on it. Refacing keeps every box exactly where it is.
Not enough storage
Same boxes, same volume. You can add pull-outs and organisers inside them, which helps more than people expect, but the footprint does not change.
Damaged boxes
See above. This is the one that matters.
Worn-out interiors
Refacing is a face treatment. If the shelves are sagging and the interiors are tired, you will see it every time you open a door.

What it is genuinely good at

Speed, mess and money, in that order. A refacing job is usually a few days rather than a few weeks, it generates a fraction of the dust and demolition, and you keep using the kitchen through most of it.

It is also the right answer surprisingly often in houses of a certain age. Seven in ten homes in Kingwood's 77345 were built between 1980 and 1999 (American Community Survey, 2024 five-year estimates), and a lot of them were built with better carcasses than the doors on the front of them would suggest.

If you are refacing, change the hardware too

Hinges and drawer slides are the parts you actually touch a hundred times a week, and thirty-year-old ones are usually the reason a kitchen feels old even after new doors go on. Soft-close hinges and full-extension slides cost very little in the context of the job and they change how the kitchen feels daily.

While the doors are off is also the cheapest moment there will ever be to add pull-outs to the deep corner cabinet and a pan drawer beside the range.

Thinking about this job?

Kitchen Remodeling

From the initial consultation to the final touch: cabinets, counters, flooring and paint.

Read the full page

Start here

Start with a free estimate.

A free in-home consultation and a written estimate, with no obligation at the end of it.

  • Rated 4.8 on Google across 32 reviews
  • Renovating North Houston homes since 2005
  • Free in-home consultation, no obligation
(713) 757-2790
Step 1 of 4Project
What would you like to transform?
CallFree estimate